Kenwood COMPACT DISC DIGITAL AUDIO UD-703 - Manual (Page 54)

Program edit recording
UD-703/753 (EnJ
Use the following procedure to record CD tracks in the order
g j i programmed by yourself so that no tune is interrupted in the
middle at the ends of tape sides.
_ I ThetuneinterruptedattheendoftapesideAiserasedandside
B starts from the beginning of that tune.
UD-753 only
For the operation of UD-703: to -1^
• Load a cassette tape in deck B.
• Select the tape transport direction or ►).
• Select "cio","7=D" (two-side recording}.
• Select the Dolby NR nnode.
I • Select the "CD” input. |
• Insert disc(s) in the CD player.
Press so that the "PGM" indicator lights.
Only “SINGLE TIME” display is
shown in PGM mode.
P.MODE
I n n - f i n r
u- Liu II
a 3 4 s
7 8 9 10
11 12 13 14 15
6 17 18 19 20
I Enter disc Nos. and track Nos. in the order you
want to record them. (Editing)
MD
O Enter the disc No.
I Within 8 seconds}
> Enter the track No.
To edit tracks from more than one CD, repeat
O and O for each CD.
Press the numeric keys as shown below...._________
To enter track Nos. 2, 5 and 25; [11 [Tio] pio]
Displays the entered track No.
IS
^
SS n M// l O E P - 0 1
• Select CD tracks so that their total playing time does not exceed the
recording time of the tape.
• Upto32 tracks can be programmed. When "FULL" isdisplayed, no more
tracks can be programmed.
• If you make a mistake, press the CLEAR key and enter the track No. from
the beginning.
• The CCRS setting will not occur if the track No. is not selected within 8
seconds after having selected the disc No.
• The REPEAT key is invalid.
To check the edited contents
To clear the edited contents
Start edit recording.
• The recording level and bias will be adjusted automatically in approx. 90
seconds (variable depending on CD contents), after which recording
starts.
• In editing from more than one CD, the CCRS setting operation is
performed after every disc change. In this case, the deck stops automati­
cally and restart recording after having completed the CCRS operation.
rrj--------- 1 1. When the CCRS key is pressed during playback of CD, the playback stops and the CCRS setting (preparation for edited recording) starts.
2. The automatic recording level setting operation in the edit recording utilizes a section suitable for this purpose in the CD present in the CD
player.
3. Edit recording is not possible with CDs containing a track that is longer than one tape side, which may occur with classical music, etc.
4. If the deck is set for one-side recording (zzi), the processing at the tape end is applied only on side A.