Recording (deck b only), Preparation for recording – Kenwood COMPACT DISC DIGITAL AUDIO UD-703 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording (Deck B only)
This unit incorporates the CRLS (Computer Recording Level
System), automatic recording level setting and Dolby HX Pro
headroom extension to allow excellent sound recording with
simple operation.
Preparation for recording
UD-703/753 [En]
Load a tape in deck B.
I
O open the door of deck B.
© Insert a tape. _
O Close the door.
Select the tape transport direction.
Select the recording mode.
_o o o
Select the Dolby NR mode.
•The type of tape, that is, Normal, Chrome or Metal, is set automatically.
• Remove tape slack before loading.
•When the microphone is not used, set the
MIC MIXING
control fully
counterclockwise to the minimum position.
•When recording is started, the tape is transported in the direction selected
in this step.
•Wind the tape to the position where recording is to be started.
Each press of the key switches the modes as follows.
® "cio"........................(Inthiscase, too, the two tape sides are recorded,
after which recording stops.)
(2) "xzt"............... tape side is recorded, after which recording
stops.
d) "z=
5
"............. ........The two tape sides are recorded, after which
recording stops.
Each press of the key switches the modes as follows.
DOLBY NR “B”
..B type (general type).
d)
DOLBY NR “C”
..... C type (with higher performance).
(D DOLBY NR “OFF”
(no indication).......... Dolby NR is not used.