Kenwood COMPACT DISC DIGITAL AUDIO UD-703 - Manual (Page 57)

Al edit recording
In case the recording time of tape is shorter than the playing
time of the CD to be recorded, all of CD tracks can be accommo­
dated by fading out the ending parts.
UD-753 only
For the operation of UD-703: to -gp
UD-703/753 (En]
Preparation • Load a cassette tape in deck B.
• Select the tape transport direction (◄ or ►
• Select (two-side recording).
• Select the Dolby NR mode.
• Select the
“CD" input. |
• Insert disc(s) in the CD player.
Press so that the "PGM" indicator goes off.
Enter the disc and tape conditions.
m
t>
When you repeat Al edit recording (CCRS), be sure to start
from step □.
Should be OFF.
I n i /7--0D"
Each press switches the edit modes as follows,
r.- ©EDIT
L (DAI EDIT
Press so that the "Al EDIT” indicator lights.
Lights. Lignis. I
d I s e n
12 3 4 5
7 8 9 10
12 13 14 15
IB 17 18 19 20
•The SPACE key and REPEAT key are invalid.
L-i- I vN
1 2 3 4 5
9 10
C-41 12 13 14 15
17 18 19 20
Press the numeric keys as shown below....
30-minute tape: i+10| |+10l k1D| 0
46-minute tape: l+10| |+10| |+10| [+10| fs]
46-, 54-, 60- or 90-minute tapes can be selected simply by pressing the
TIME key for the required number of times. (The recording time can be
adjusted in 1-minute steps with the and keys.)
After entry, press the EDIT MODE key then proceed to step □.
• CD tracks will be edited automatically onto tape sides A and B. After
editing, the “Al EDIT” indicator stops blinking and starts to light steadily.
• If an extremely short time is specified, editing may not occur or the CD
tracks programmed for Al priority editing may be faded out.
• The recording level and bias will be adjusted automatically in approx. 90
seconds (variable depending on CD contents), after which recording
starts.
• The tape and CD stop automatically when recording has completed.