Kenwood COMPACT DISC DIGITAL AUDIO UD-703 - Manual (Page 19)

0 While the L.LC. indicator is blinking, settheLL.C. volume with
the VOLUME CONTROL or from the remote control unit.
G Press the L.L.C, key again while the L.L.C. indicator is blinking.
• When the key is pressed again after the L.L.C. indicator has finished
flashing, this function is cancelled.
• If a larger L.L.C. volume than 29 is set, the bass and treble tones will
not be compensated.
Playing sound with higher purity
Switching SOURCE DIRECT ON simplifies the s
and thereby improves the purity of sound.
DIRECT
»When the SOURCE DIRECT is ON, the SOURCE DIRECT indicators
on the front panel lights.
»Press the key again to cancel the SOURCE DIRECT.
To decrease To increase
volume volume
i / n i I / M O m
^ / ^ u o u / / L l u
Volume display
• When the L.L.C. key is pressed to ON, these controls function as the
L.L.C. volume control.
Muting the sound temporarily
Remote control unit only
^ l J]
► Press again to resume the original volume.
Adjusting the lefl/right volume balance
Indicates the center.
Indicates the balance setting.
1....... -W -R
To decrease balance
O)
----
O)
To decrease
Right volume Left volume
r 77
m L J J
/Vi
► Press the key again to cancel the N.B. CIRCUIT.
Compensation of bass sound
N.B.CIRCUIT: Natural Bass CIRCUIT
Press to ON to activate automatic adjust­
ment of bass tone.
N.B.CIRCUIT
Input selection on the amplifier unit and easy operation function
With the easy operation function, simply selecting an input source with the input selector keys (TAPE, TUNER, CD, MD, etc.) of the amplifier unit start playback
of the selected source component. On the contrary, starting playing a component switches the input selectors automatically to that input source.
The same operation is also possible with the INPUT key of the remote control unit. When the power is switched ON, the source which has been input before
the power was switched OFF last time (TUNER, CD, etc.) will be played.