Kenwood COMPACT DISC DIGITAL AUDIO UD-703 - Manual (Page 75)

UD-7Ü3/753 [En]
Cassette deck unit
Symptom Cause Remedv
Sound cannot be produced by pressing • The connections cords are wrong. • Connect properly referring to " System connec­
the play key or no operation occurs even tions".
when an operation key is pressed. • The head is dirty. • Clean the head referring to "Maintenance".
-w
•The tape is wound too tight due to irregular
winding.
•Try another tape.
• A nonrecorded tape is played. • Play a recorded tape.
No operation occurs even when an op- • The cassette holder is not closed completely. • Close the holder completely.
eration key is pressed. • The operation key is pressed immediately after • Press operations keys in more than a few
closing the cassette holder. seconds after closing the holder.
•The operation key is pressed in less than 4 • Press operation keys after waiting for more
seconds after turning the power ON. than 4 seconds.
• A tape is not inserted in the unit. • Inserts tape.
•The tape is wound too tight due to irregular
winding.
•Try another tape.
• The tape is fully wound to one of the reels. • Change the tape transport direction or reverse
the tape insertion orientation.
The DPSS malfunctions. • The tape used is not suitable for DPSS, for example
the spaces between tunes may be too short.
• Refer to " Skip search ". -I22
The OCRS does not function. • A recordable tape is not present in deck B. • Insert a recordable tape in deck B and retry
operation.
• A disc is not present in the CD player. • Place a disc in the CD playerand retry operation.
• The disc is dirty. • Clean the disc, place it in the CD player and try
the operation again. *[S3
In dubbing, the tape stops at different • This is due to the difference in the tape length or • Small time difference does not mean a mal­
moments in decks A and B. characteristics of the mechanisms of two cas­
sette decks. function.
The cassette holder cannot be opened by • The key is pressed during recording or playback. • Press in stop mode.
pressing the eject key. • The microcomputer is malfunctioning due to
external noise.
• Unplug the power cord and plug it again.
Sound is harsh or high frequencies are • The head is dirty. • Clean the head referring to "Maintenance".
not reproduced.
• The tape is stretched or shrunk. • Try another tape.
Sound is distorted. •The tape being played was recorded with dis­
torted sound.
•Try another tape.
Noise is noticeable. • The tape head is magnetized. • Demagnetize the head referring to "Mainte­
nance".
• External noise is induced. • Install the system at a distance from other
electric appliances and TV.
• Atape recorded with Dolby NR ON is played with
Dolby NR OFF.
• Set the Dolby NR to on. “(32
Sound vibrates. •The capstans or pinch rollers are dirty. • Clean the head referring to "Maintenance".
• The tape is wound irregularly. • Wind the tape again by fast forwarding, re­
winding or playing from an end to the other.
Recording cannot be started by pressing • The recording protect tab of the cassette has • Use a cassette with an unbroken recording
the record key. been broken. protect tab or block the hole.
• The cassette holder is not closed completely. • Close the holder completely.
• The TAPE input is selected. • Select the source to be recorded with the input
selector key.
• The tape is fully wound to one of the reels. • Change the tape transport direction of deck B
or reverse the tape insertion orientation.
Volume of the recorded track changed. • MIC MIXING control knob is moved during • Fully turn the MIC MIXING control knob to the
recording. left. i