Auto space function, To add a track to the program, To change a track in the program – Kenwood COMPACT DISC DIGITAL AUDIO UD-703 User Manual
Page 30: To clear tracks from the program
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UD-753 only
For the operation of UD-703:
to
Auto space function
When the
SPACE
key is pressed during programming of tracks, a non-
recorded space of a few seconds will be created between tracks. By
recording tracks with these spaces on tape, the search and repeat play
operations of tape using the DPSS function {which works by searching the
non-recorded spaces) can be performed reliably.
UD-703/753 [En]
• Even when the performances of two tracks are continuous (which occurs
with classical or live recording music), the spaces will be created if they
have different track Nos.
• To cancel the auto space function, press the
P.MODE
key or the
SPACE
key again.
To add a track to the program
•When a track No. is entered, the track will be added to the end of the
existing program.
To change a track in the program
lights.
505
P -
05
• Press the
CHECK
key repeatedly until the track No, to be changed is
displayed.
• Press while the
P.C.
indicator is lit
• The track being played cannot be changed.
To clear tracks from the program
• Each time the key is pressed, the last track in the program is cleared.
•The track being played cannot be cleared.
•The entire programmed contents are also cleared when the Open/Close
(^) key is pressed.