Kenwood COMPACT DISC DIGITAL AUDIO UD-703 - Manual (Page 18)

Sound adjustment functions
Power ON/OFF
Press the POWER key of the amplifier unit.
STANDBY indicator
Qs’
Rennote control unit
• The power of the overall system can be turned ON/OFF by pressing
the POWER key of amplifier unit.
Enhanced bass entertainment with super
woofer (optional)
i Press the S.WOOFER POWER key.
PHASE TURHQVEB
CD CD CD
Remote control unit
(Point remote control unit at the super woofer.)
© Adjust the super woofer volume.
a'
To decrease
volume
(Point remote control unit at
the super woofer.)
It can also be adjusted with the
volume control provided on the
super woofer.
■ Once the super woofer volume has been set, it will increase or
decrease according to the VOLUME CONTROL adjustment.
• For the PHASE and TURNOVER key settings, read the instruction
manual of your super woofer.
UD'703/753 [En)
Listening at a low volume (LLC.: Low Level Control)
Tlie volume set for quiet listening (L.L.C. volume) can be
recalled with a one-touch operation.
Blinks. -> Lights.
(For a few seconds)
• The volume is decreased and the bass and treble tones are compensated.
•When L.L.C. is ON, amount of volume varied by rotating the VOLUME
CONTROL becomes constant regardless of the speed the control is
rotated.
• If the L.L.C. volume which has been stored in memory is higher than
the current listening volume, the volume will not be changed by
pressing this key.
• The volume does not return to the original level even after L.L.C. has
been switched OFF. Adjust the volume as desired.
Listening through headphones
O Insert the headphone plug into the PHONES jack.
• The sounds from all speakers are cut off.
© Adjust the volume.
• Minimize the volume before plugging or unplugging the plug.
STANDBY mode of POWER switch
When the power cord is plugged into an AC outlet the STANDBY indicator lights regardless of the power ON/OFF setting. This is because, even when the
power is set to OFF, a small amount of power is supplied to the system to back up the memory. This status is called the standby mode of the system. While
the STANDBY indicator is lit the power can also be turned ON/OFF from the remote control unit.