Casio ClassPad 300 - Manual (Page 549)

20021201
Stop
Syntax: Stop
Function: This command terminates program execution.
Description: This command terminates all program execution, including that of the main
program when a subroutine program is running.
Switch~Case~Default~SwitchEnd
Syntax: Switch
Ⅺ
Case
Ⅺ
[] …
Case
Ⅺ …
[] …
…
Case
Ⅺ n >
[] …
[Default]
[] …
SwitchEnd
through n > should be expressions that produce real
numbers.
Function: This command executes one of a series of processes based on the value of
.
Description
• This command executes the statement following the Case expression that matches the
Switch expression.
• If there is no matching Case expression, the statement following Default is executed. If
there is no Default specified, a non-match jumps to the statement following SwitchEnd.
• You can use a multi-statement command (:) in place of the carriage return to separate
statements.
• Switch~SwitchEnd can be exited using the Break command, Return command, or Goto
command.
Wait
Syntax: Wait
Ⅺ []
Function: This command pauses program execution, and then restarts it after the number
of seconds specified by the expression passes.
Description
• If you do not specify any expression, program execution is paused until you tap the screen,
or press a key.
• The maximum valid specification for is 360 seconds (six minutes). Specifying
a value greater than 360 causes program execution to resume after 360 seconds,
regardless of the specified value.
• The ClassPad’s Auto Power Off function is disabled during a pause caused by the Wait
command.
12-6-14
Program Command Reference