Carl Goldberg GBGA0067 - Manual (Page 7)

7. ‡ Trimming as needed, prefit the SHEETING
onto the stab. When satisfied with the fit, CA
glue in place.
8. ‡ Flip the stab over and sheet the other side.
ELEVATOR
1. ‡ Laminate the two sets of ELEVATOR AIR BAL-
ANCE L.E.s and ELEVATOR HORN MOUNTS.
2. ‡ Place waxed paper over the elevator portion of
the plan.
3. ‡ Working over the plan, glue and pin the ELE-
VATOR AIR BALANCE L.E.s and the ELEVA-
TOR HORN MOUNTS in place.
4. ‡ Trim each PERIMETER STICK, as needed,
and glue and pin in place over the plan.
6. ‡ Trim and glue the TRUSSING in place.
5. ‡ Trim the STAB LEADING EDGES and TIPS to
fit.
‡ Pin in place and glue.
7
1/4 x 5/16 x 16"
1/4 x 5/16x24"
1/8 x 1/4 x 20"
3/8" SQ. BALSA
5/64” BALSA