Carl Goldberg GBGA0067 - Manual (Page 22)

FUSELAGE CONSTRUCTION
1. Gather the parts needed to construct the fuselage.
(2) D/C SHT.6728 LITE PLY PT. #3655
FUSE. SIDE/COWL SIDE SUPPORT
(1) D/C SHT. 6729 LITE PLY PT. #3651
FORMER "A", "C" & "D"
(1) D/C SHT. 6704 LITE PLY PT .#3663
FORMER "F","G","H" & "J"
(1) D/C SHT.6724 LITE PLY PT. #3659
CONTAINS:
(1) FUEL TANK TRAY
(1) MOTOR MOUNT BOTTOM
(1) LEFT MOTOR MOUNT SIDE
(1) RIGHT MOTOR MOUNT SIDE
(1) D/C SHT. 6706 BIRCH PLY PT. #3665
CONTAINS:
(1) FIREWALL FRONT
(1) FIREWALL AFT
(1) D/C SHT. 6707 LITE PLY PT. #3666
CONTAINS:
(1) TOP AFT
(1) WIND STOP
(2) TURTLE-DECK BACK-UP
(1) D/C SHT. 6708 PT. #3667
CONTAINS:
(1) BOTTOM AFT
(1) COWL SUPPORT-TOP
(1) D/C SHT.6709 LITE PLY PT. #3668
CONTAINS:
(1) TOP-FRONT
(1) FORMER "E"
(1) D/C SHT. 6710 BIRCH PLY PT. #3669
(1) TURTLEDECK
(2) L/C SHT. 6731 LITE PLY PT. #3653
CONTAINS:
(1) WING SADDLE DOUBLER
(1) L/C SHT. 6732 LITE PLY PT. # 3652
CONTAINS: (1) FORMER B
(1) FORMER B2
(1) LANDING GEAR PLATE
(1) WING MOUNTING BLOCK PT. #3672
7/16" TAPER x 5-1/8" BASS
(1) FRONT TOP SHEET PT. #3673
1/32 x 8 x 9-1/2" BIRCH PLY
(3) GUSSET PT. #4217
1/2" TRI x 8" BALSA
(1) .078 x 13-5/8” THREADED ROD PT. #1281
(2) ENGINE MOUNT PT. #1466
(6) 6-32 BLIND NUTS PT .#1124
(2) 6-32 x 1" SOCKET HEAD SCREW PT. #1023
(2) #6 FLAT WASHER PT. #1140
(2) #6 x 3/4" O.D. FLAT WASHER PT. #1144
(1) FUSELAGE PLAN PT. #2123
2. ‡ Making sure the marking lines are facing out
and that the perimeter is lined up, laminate the
two 1/8” birch plywood FIREWALL parts with
SUPER JET.
22
MARKING LINES FACING UP