Carl Goldberg GBGA0067 User Manual
Page 17
29. Trim and then glue the WING TIP SHEETING
and the 5/64” balsa capstrips in place.
THIS COMPLETES THE RIGHT WING HALF. SET IT
ASIDE AND PLACE THE LEFT WING HALF OF THE
PLAN IN THE CENTER OF THE BUILDING BOARD.
Begin building the left wing at Step 3.
DO NOT BUILD THE SECOND WING PANEL OVER
THE SAME PORTION OF THE PLAN!
WHEN THE SECOND WING PANEL IS COMPLETE,
REMOVE IT FROM THE BOARD AND CONTINUE TO
THE NEXT STEP.
30. Assemble the DIHEDRAL FIXTURES, as
shown. Note that one is offset. This fixture will
not be needed in construction of this second edi-
tion Sukhoi.
31. Working over the full waxed-paper-covered wing
plan, pin or glue the fixtures in place, as shown
above.
32. Place the wing panels onto the fixtures with the
bottom (open framework) facing up.
Check the centerline fit and, if necessary, sand
to improve fit.
When satisfied with the fit, you may wish to
anchor in place with pins and rubber bands, as
shown.
33. Carefully remove the reinforcing tape and crack
off all of the wing support tabs.
34. Test fit and then glue the MAIN SPARS to each
wing rib.
17
OFFSET
"S"
"S"
CRACK
"T"
"T"
"R"
WING IS BOTTOM-SIDE UP