Carl Goldberg GBGA0067 - Manual (Page 6)

TAIL CONSTRUCTION
1. Collect the following items:
(1) D/C SHT. 6711 BALSA PT. # 3670
CONTAINS:
(4) ELEVATOR AIR BALANCE L.E.
(2) RUDDER BOTTOM
(2) RUDDER TOP
(1) D/C SHT. 6712 PLY PT. #3671
CONTAINS ROUNDING TOOL
(1) D/C SHT. 6727 BALSA PT. #3657
CONTAINS:
(1) STAB JOINER
(4) ELEVATOR HORN MOUNT
(1) D/C SHT. 6723 PLY PT. #3697
CONTAINS BEVEL TOOL
(1) D/C SHT. 6710 PLY PT. #3669
CONTAINS:
(2) STAB JOINER DOUBLER
(3) TRUSSING STICKS PT. #3675
1/4 x 1/8 x 20” BALSA
(4) RUDDER TRUSSING PT. #3676
1/8 x 3/8 x 12” BALSA
(1) STAB T.E. DOUBLER PT. #3677
1/4 x 5/16 x 12” BALSA
(2) STAB L.E. & TIP PT. #3678
1/4 x 5/16 x 16” BALSA
(3) PERIMETER STICKS PT. #3679
1/4 x 5/16 x 24” BALSA
(2) ELEVATOR TRUSSING PT. #3680
3/16 x 3/8 x 20” BALSA
(1) RUDDER TRAILING EDGE PT. #3681
5/16 x 3/8 x 20” BALSA
(8) ELEVATOR PERIMETER STICK PT. #3682
3/8” SQ. x 12” BALSA
(1) RUDDER LEADING EDGE PT. #3683
3/8” SQ. x 18” BALSA
(1) STAB PLATFORM PT. #3684
1/4 x 2-1/2 x 3-3/4” BALSA
(4) STAB/FIN SHEETING PT. #3685
5/64 x 3 x 24” BALSA
(2) FIN SHEETING PT. #3686
5/64 x 3 x 18” BALSA
(1) CENTERLINE MARKING TOOL PT. #1425
HORIZONTAL STABILIZER
2. ‡ Place the WING PLAN on the building board
and cover the horizontal stabilizer portion of
the plan with waxed paper.
3. ‡ Glue a STAB JOINER DOUBLERS to each
side of the STAB JOINER, as shown above.
4. ‡ Glue and pin the JOINER ASSEMBLY, STAB
PLATFORM and T.E. DOUBLER over the plan.
(10) LARGE FLEX POINT HINGE PT. #1449
(1) WING PLAN PT. #2124
(1) FUSELAGE PLAN PT. #2123
6
3/16" BALSA
1/32" PLY
PLAN
1/4 x 2-1/2 x 3-3/4" BALSA
1/4 x 5/16 x 12"