Carl Goldberg GBGA0067 - Manual (Page 29)

FINISHING THE MODEL
CANOPY INSTALLATION
1. ‡ You will need the canopy and paint or covering.
2. ‡ Cover the cockpit interior with black or gray
iron on film or paint, as preferred.
3. ‡ Trim the canopy around the perimeter, along
the trim line.
4. ‡ Using epoxy or a clear canopy glue, glue the
canopy overlap to the fuselage sides and
around the front and back of the cockpit.
FUEL TANK INSTALLATION
1. ‡ Gather the following items:
(1) D/C SHT. 6724 PT. #3659
TANK TRAY
(1) FUEL TANK NOT INCLUDED
(1) 12” LENGTH OF FUEL LINE NOT INCLUDED
(2) #64 RUBBER BANDS NOT INCLUDED
(1) FOAM PADDING NOT INCLUDED
2. ‡ Rubber band the foam pad and the fuel tank to
the tank tray.
3. ‡ Thread the fuel line through the “V” notch in the
firewall and attach them to the tank.
‡ Pull the line forward and glue the tank assem-
bly onto the locating shoulders on Former A
and Former B, inside the fuselage.
‡ Connect the fuel lines when you mount the
engine.
TAILWHEEL ASSEMBLY
1. ‡ Collect the following items:
(1) TAILWHEEL ASSEMBLY PT. #5819
(1) ADJUSTABLE HORN BRACKET PT. #1424
(2) #2 x 3/8” SHT. METAL SCREW PT. #1084
(1) 1-1/4” TAILWHEEL NOT INCLUDED
(2) CGP 3/32” WHEEL COLLAR NOT INCLUDED
2. ‡ Cut a narrow slot through the fuse bottom and
secure the tailwheel brack assembly with the
#2 x 3/8” screws.
3. ‡ Notch the bottom of the rudder to mount the
horn bracket.
‡ Slide the bracket into the wire and glue into the
notch. DO NOT GLUE BRACKET TO WIRE.
4. ‡ Trim the wire and install tailwheel, as shown.
29
#2 x 3/8" SCREW
HORN BRACKET
CUT SLOT
NOTCH
FUEL TANK TRAY