Carl Goldberg GBGA0067 - Manual (Page 37)

SETTING CONTROL SURFACE TRAVEL
Use the control surface travel gauges to correctly set
up the surface deflections. The gauges provide you
with two setting: a gentle response setting and a more
aerobatic setting. Even if you are an experienced pilot,
we encourage you to start out at the gentle setting and
then move to the aerobatic mode after you become
more familiar with the characteristics of this aircraft.
AILERON GAUGE
ELEVATOR GAUGE
RUDDER GAUGE
1. ‡ Place the gauge anywhere along the wing.
Align the center of the aileron to the mark in the
neutral position.
‡ With the control stick full left and full right,
match the center of the aileron to the mark.
2. ‡ Adjust the horn bracket up or down along the
hole selection to achieve the correct travel set-
ting.
NOTE: This is a good time to make sure the control
surfaces are responding correctly. You would
not want to correct a left bank with more left, so
check it now!
1. ‡ Place the elevator gauge anywhere along the
elevator hinge line.
2. ‡ Adjust the servo arm hole along with the con-
trol horn hole to achieve the desired setting.
Check each elevator.
1. ‡ Position the rudder gauge at the top of the fin at
the hinge line. Follow the same procedure
used for the elevator to achieve the desired
travel.
37
HIGH THROW
LOW THROW
HIGH THROW LOW THROW
HIGH THROW
LOW THROW
UP ELEVATOR
NOTCH POINTS UP
NOTCH POINTS
DOWN
3/16"
3/8"
1/4"
LEFT AND RIGHT RUDDER
DOWN ELEVATOR