A&D Weighing HW-1200KGV3 - Manual (Page 74)

Page 72 HV-G/HW-G Series 17. Options
Zero
The current mass value is set to the zero point.
This is the same as the
ZERO
key.
Template Z
Command
Reply
The mass value becomes zero and zero point mark is displayed.
Tare
With a tare (container) placed, the current mass value is set to zero, and the net is
displayed. This is the same as the
TARE
key.
Template T
Command
Reply
The current mass value becomes zero and the net mark is displayed.
Cancel of tare
The weight value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template CT
Command
Reply
Gross is displayed and the net mark is turned off.
Preset tare
The tare value is set and the net is displayed. The net mark is displayed.
The set value is a 5 digit numerical value with a polarity sign and does not contain a
decimal point.
Template PT, [parameter]
Command
Reply
Net is displayed and the net mark is displayed.
Upper limit value
The upper limit value is stored. The set value is a 5 digit numerical value with a
polarity sign and does not contain a decimal point.
Template HI, [parameter]
Command
Reply
The upper limit value is stored.
Caution The upper limit value must be greater than the lower limit value.
Lower limit value
The lower limit value is stored. The set value is a 5 digit numerical value with a polarity
sign and does not contain a decimal point.
Template LO, [parameter]
Command
Reply
The lower limit value is stored.
Caution The lower limit value must be less than the upper limit value.