Kofax SupplierExpress - Manual (Page 73)

SupplierExpress Administrator's Guide 73
Appendix B
Testing SupplierExpress
Test your installation in a non-production environment.
Completing Pre-Testing Tasks
1 Verify the following:
▪ The SupplierExpress Agent is installed and configured in the non-production
environment.
▪ (MarkView integration only) You have the name of a MarkView User Groups that will
have access to SupplierExpress.
▪ The person who will perform the testing:
▪ Has a user account (username and password).
▪ (MarkView integration only) Is a member of one of the MarkView User Groups
that will have access to SupplierExpress.
2 Use the Company URL provided by the Kofax Technical Support team to test your
installation.
Note The Technical Support team will ask you for the name of the buyer or MarkView
User Groups that need access to SupplierExpress.
3 Book mark the Company URL. The person performing the tests uses the Company URL to
simulate activities by your company (for example, Greener Ways users).
Mapping Suppliers and Email Addresses
For the best results while testing, associate a supplier with a unique contact and email
address. This setup simplifies the results of email notification testing. For example, use a
different contact for each supplier:
▪ A1 Lighting—[email protected]
▪ B2 Flooring—[email protected]
▪ XYZ Windows—[email protected]
SupplierExpress supports having a single contact for more than one supplier.
Testing
To log in as a different user from the same computer when testing, always click Logout in
SupplierExpress between log ins. If you fail to do so, SupplierExpress uses the credentials of
the previously logged in user.
For example, the tester may log in as a Buyer and then need to log in as a Supplier on the
same computer. Before closing the Company browser session and logging in as the Supplier,
the tester must click Logout.