KEYENCE TM-3000 Series - Manual (Page 8)

8
IV -
33
Manual P2-9
This section explains how to set the measurement area. By setting the measurement area at a desired location,
measurement points can be specified. Use this setting method when using the measurement setting or position
correction.
The measurement area to operate differs depending on the measurement type.
For details, see User’s Manual P2-9.
Following is the setting after step 4 for “Diameter measurement” on page 4 in this manual.
* This is the example of when selecting “Diameter” for the measurement type.
Select “Area 1” on screen 1.
Press the [ENTER] key on the console to select the item.
Select “Drawing” on screen 2. Then, the cursor appears on upper left of the measurement area.
With the cursor displayed on the screen, operate the [ENTER] key up, down, right or left on the
console and change the measurement area.
Press the [SCREEN] key to select the point to operate.
Press the [ENTER] key on the console to finish the setting.
Press the [ESCAPE] key to return to the screen.
Area setting
XXX
Specifying measurement points
Screen 1 Screen 2
Setting procedure
The side with the arrow
can be moved. The entire area can be
moved without
changing the area size.
How to change the cursor
ENTER
ESCAPE
MENU
PROG
NO. SCREEN
ZERO
TRG/
HOLD
[SCREEN] key
Console
[SCREEN] [SCREEN]
1
2
1
2
3