KEYENCE TM-3000 Series - Manual

TM-3000
Setup guide
This guide describes the basic operations for TM-3000.
For operation details, see "User's Manual".
High-speed 2D Measurement Sensor
I Introduction
Wiring
Installation P 2
P 2 I -1
I -2
II Operational Flow for Measurement
Operational flow for measurement II -1
III Measurement – diameter and step height of a stepped shaft
Diameter measurement
Step height measurement Measuring the outer diameter of a target
Measuring the step height of a target III -1
III -2
IV Settings/Operations Used for All Measurements
Master registration
Measurement setting
Area setting Registering an image to be used as a measurement standard
Making detailed measurement settings
Specifying measurement points IV -1
IV -2
IV -3
V
Position correction Measuring correcting the margin of error
caused by the position change of the target V -1
VI Frequently Used Settings
External Trigger
Offset
Scaling
Tolerance
Initialization Measuring synchronizing with the external signal input
Setting the displayed value to an arbitrary value
Correcting measured values
Making the tolerance setting
Restoring the default status VI -1
VI -2
VI -3
VI -4
VI -5
VII Settings for Data Saving
Data storage function
Excel transfer function
Image storage function
Image capture function Storing measurement data
Displaying the storage data on the Excel file
Saving the image data of measurement targets
Saving the monitor images VII -1
VII -2
VII -3
VII -4
P 3
P 9
P 6
P 7
P 8
P10
P10
P11
P11
P11
P12
P13
P14
P15
P 4
P 5
Setting for Correcting the Position of the Target
96M11229