KEYENCE TM-3000 Series - Manual (Page 14)

14
VII -
33
Manual P5-98
Image storage function
XXX
Saving the stored data of measurement targets
Screen 1 Screen 2
Setting procedure
Select “Common” on the setting screen (screen 1).
Press the [ENTER] key on the console to select the item.
Select “Storage” on screen 1.
Select “Image storage” from the pull-down menu on screen 1.
Slide the [PROG/RUN] switch on the side of the console to move to screen 2.
On screen 2, press the [MENU] key on the console to display “Display setting” dialog.
Press the “Storage start/stop” button to start storage.
Image storage using the external trigger
By using the external trigger, the image data can be stored for each
trigger input.
Change the trigger mode to "EXT trigger". (See page 10 in this
manual.)
Make the setting for image storage.
Set "Storage mode" to “Always”. (See page 14 in this manual.)
Return to the measurement screen and input the trigger.
Procedure
1
2
3
Slide the [PROG/RUN] switch on the side of the console to display the settings screen (screen 1).
The “Storage” mark is
displayed when storage
begins.
This stores measured images. Up to 100 images can be stored.
The stored images can be loaded and analyzed, using the setup support software TM-Navigator.
1
1
2
3
4
5
2
3
5