KEYENCE TM-3000 Series - Manual (Page 10)

10
VI -
11
Manual P5-3
Use this mode to measure synchronizing with the trigger input.
Select “Head setting” on the setting screen (screen 1).
Select “Trigger settings”.
Change to “EXT trigger” in “Trigger mode”.
Input the trigger.
Trigger mode
XXX
Measuring synchronizing with the external signal input
Screen 1
Setting procedure
This section explains the frequently used settings.
Frequently Used Settings Frequently Used Settings
Method 1
Method 2
Method 3
Input from the console
Trigger input method
Input from the external terminal
Input from the RS-232C interface
Method 1
Method 2
Method 3
Input from the console
Input from the external terminal
Input from the RS-232C interface
VI -
2
Manual P5-87
Use this setting to change the current measurement value (display value) to an arbitrary value by ZERO input.
Select “OUT setting” on the setting screen (screen 1).
Select “OUT” to change the setting.
Select “Off set” value.
Input Auto-zero.
Offset
XXX
Setting the display value to an arbitrary value
Screen 1
Setting procedure
Auto-zero input method
2
Display value
0
Execute ZERO
t
When the value input for
the auto-zero is “0.000”,
the measurement value
changes as shown at
left.
VI
1
2
3
4
1 2
3
3
1
2
1
2
3
4