Cub Cadet T2-HP - Manual (Page 38)

34 T2 ®
If the unit has been torn down completely, the
following summary identifies the assembly pro-
cedures necessary to completely assemble the
unit . Each assembly procedure is located by a
page reference .
The part reference numbers provided in each
assembly procedure are keyed to the individual
procedure illustrations, and are also keyed to
the complete unit exploded view on page 36 .
1. Install the expansion tank hose and fitting.
See page 33 .
2 . Install the LH axle assembly . See page
32 .
3. Install the filter assembly, cylinder block and
motor shaft . See pages 30-31 .
4 . Install the bypass arm . See page 29 .
5 . Install the pump block and swash plate . See
page 28 .
6 . Install the input shaft . See page 27 .
7 . Install the reduction gear set . See page
26 .
8 . Install the bull gear set . See page 25 .
9 . Install the RH axle assembly . See page
24 .
figure 28, sealant application diagram
assembly afTer a COmpleTe Tear dOwn
10 . Apply sealant to the main housing prior to
assembly with the side housing . See page
34 .
NOTE: Prior to applying the new sealant, the
old sealant must be removed from all
surfaces.
A small consistent bead (approx.
1/16 – 1/8 inch) of the sealant around
the housing face will be sufficient. Use
sparingly.
The illustration below indicates the cor-
rect sealant path.
11 . Install the brake assembly . See page 22 .
12 . Install the control arm (RTN) assembly . See
pages 19-21 .
13 . Install the expansion tank . See page 18 .
14 . Fill transaxle with clean oil .
15 . Install the fan and pulley assembly . See
page 17 .
16 . Install the transaxle into the vehicle .
17 . Perform the purge procedures listed on
page 11 .
Sealant Path for Main Housing