Cub Cadet T2-HP - Manual (Page 32)

28 T2 ®
swasHplaTe
figure 20, swash plate
Refer to Figures 20-21
disassembly
1 . Requires removal of all items beginning on
page 17 .
2 . Remove the swashplate (40) and pump
cylinder block assembly (70) as a single
item .
NOTE: Removal will be aided by applying a
small amount of pressure on the trun-
nion mounted swashplate towards the
center section. While CAREFULLY
removing the swashplate and block as-
sembly, keep the block face flush with
the center section to minimize damage
to the running surface.
3 . Separate the pump cylinder block assembly
(70) and the thrust bearing (74) from the
swashplate (40) and set aside .
Inspection
1 . Inspect the swashplate (40) and thrust
bearing assembly (74) for wear or damage .
Replace if necessary .
2 . Inspect pump block per detail on page 31 .
assembly
1 . Reassemble all parts in the reverse order
of disassembly .
2 . Apply a light coating of oil to running sur-
faces on center section, swashplate bearing
races, thrust bearing assembly and pump
block assembly .
3 . Place the thrust bearing assembly (74) into
swashplate (40) .
4 . With the pistons facing the thrust bearing,
place the pump block assembly (70) into the
swashplate .
5 . While pressing the pump block assembly
(thrust bearing – pump cylinder block) and
swashplate together, align to center section
in main housing .
figure 21, Hydraulic pump Components
40
74
70
70
40