Cub Cadet T2-HP - Manual (Page 24)

20 T2 ®
reTurn TO neuTral assembly OpTIOn
Refer to Figure 12
disassembly
1 . Remove all items previously discussed in
their recommended order .
2 . Remove the spring (167) .
3 . Remove the Torx head screw (41) and dis-
card .
4 . Remove the scissor arm (164), and the RTN
control arm (161) .
5. Remove the Hex flange head screw (162),
the bushing (166) and the RTN neutral arm
(165) .
NOTE: Only remove the seal (110) if damaged
or worn, or if doing a complete disas-
sembly. Refer to “Seal Kit” in the Items
List on page 37.
Inspection
1 . Inspect all parts for wear or damage . Re-
place if necessary .
assembly
1 . Reassemble all parts in the reverse order
of disassembly .
2 . When tightening the fasteners, refer to the
table on page 15 for the required torque
values .
3 . Install new Torx head screw (41) and lip seal
(110) from seal kit .
NOTE: As a general rule, use the low end of
the torque specification on fasteners
when reassembling the unit.
110
167
164
161
162
166
165
figure 12, return to neutral assembly
41