Cub Cadet T2-HP - Manual (Page 25)

T2 ® 21
reTurn TO neuTral/rOs assembly OpTIOn
3 . Install the control arm (160) .
4 . Install the RTN scissor arm (164), washer
(163) and Torx head screw (41) . Refer to
torque chart on page 15 .
5 . Install the switch retainer over the neutral
arm tab . Place the rivet through the switch
retainer and neutral arm .
6 . Install the RTN spring (167) .
7 . Press down on the switch retainer tab to bias
it . Ensure that the rivet is seated . Then set
the rivet using a rivet gun .
8 . Refer to page 12 for adjusting the RTN as-
sembly .
NOTE: After installing the transaxle on the
vehicle be sure the operator presence
system and the reverse operation
system (ROS) are working properly.
Refer to the operations and mainte-
nance sections in the vehicle owner’s
manual.
Refer to Figure 13
disassembly
1 . Remove all items previously discussed in
their recommended order .
2 . Remove the spring (167) .
3 . Remove the Torx head screw (41), discard,
and the washer (163) .
4 . Remove the scissor arm (164), and the RTN
control arm (160) .
5. Remove the Hex flange head screw (162),
the bushing (166) and the RTN neutral arm
(165) .
Inspection
1 . Inspect all parts for wear or damage . Re-
place if necessary .
assembly
1 . Install the neutral arm (165) .
2 . Install the bushing (166) and the hex head
screw (162) .
160
164
163
41
162
166
167
165
figure 13, return to neutral/rOs assembly
Actuator clip
RCS switch Switch retainer