Cub Cadet T2-HP - Manual (Page 34)

30 T2 ®
CenTer seCTIOn, mOTOr sHafT & mOTOr blOCk
figure 23, Center section, motor shaft & motor block
Refer to Figure 23
disassembly
1 . Requires removal of all items beginning on
page 17 .
2 . Remove the center section mounting screws
(22) .
3 . Remove the center section, the motor shaft
(82) and the bypass plate (23) .
4 . Remove the motor cylinder block assembly
(75) .
5 . Remove the motor thrust bearing (79) .
Inspection
1 . Inspect the races of the thrust bearing (79)
for wear or damage .
2 . Inspect the motor shaft for wear or damage .
Replace if necessary .
3 . Inspect for scratches on the machined sur-
faces of the center section .
4 . Inspect motor cylinder block assembly (75)
per detail on page 30 .
5 . Inspect the bearing surfaces in the main
housing .
assembly
1 . Reassemble all parts in the reverse order
of disassembly .
2 . Apply a light coating of oil to all running
surfaces .
3 . Place the thrust bearing assembly (79) into
the main housing . Position so the thick race
will contact the motor block pistons .
4 . Insert the motor shaft assembly (82) into the
center section (20) .
5 . Insert the bypass plate (23) into the center
section .
6 . Place the motor cylinder block assembly
(75) onto the motor shaft (82) .
7 . Insert the center section (20), the motor
shaft (82), the bypass plate (23) and the mo-
tor cylinder block (75) into the main housing
as one assembly .
8 . Install the center section screws (22) . Refer
to torque chart on page 15 .
22
20
79
75
23
83
82
81
80
93
22