Cub Cadet T2-HP - Manual (Page 28)

24 T2 ®
rH aXle sHafT
Refer to Figure 16
disassembly
1 . Remove all items previously discussed, in
their recommended order .
2 . Remove the retaining ring (109) and dis-
card .
3 . Remove the lip seal (110) and discard .
4 . Remove the outboard bushing (106) .
5 . Remove the axle shaft (103) in the direction
of arrow .
6 . Remove the inner bushing (105) .
Inspection
1 . Inspect the axle shaft for wear or damage .
Replace if necessary .
assembly
1 . Assemble items in reverse order of disas-
sembly .
NOTE: To protect the lip seal from possible
damage when installing into the bore
and over the axle shaft, apply a protec-
tive covering over the splines, sharp
corners and/or keyway of the axle shaft
(e.g., cellophane, tape, etc.). Remove
protective covering after installation.
figure 16, axle assembly
106
2
103
110
109
100
101
105