Cub Cadet T2-HP - Manual (Page 33)

T2 ® 29
bypass arm
Refer to Figure 22
disassembly
1 . Remove all external items previously dis-
cussed in their recommended order .
2 . Remove the retaining ring (35) and discard .
Remove the bypass arm (34) .
3 . Remove the retaining ring (33) and dis-
card .
4 . Remove the bypass rod (32) and the clip
retaining ring (31) as a single item .
NOTE: It is not necessary to remove the clip
retaining ring (31) from the bypass rod
(32) unless it is damaged or worn.
5 . Remove the lip seal (30) and discard .
Inspection
1 . Inspect the bypass rod (32) for wear or dam-
age . Replace if necessary .
NOTE: Take care to insure that the bypass rod
is free of burrs that may cut the rubber
lip seal.
2 . Inspect the housing bore .
assembly
1 . Reassemble all parts in the reverse order
of disassembly .
2 . Install a new lip seal (30) .
3 . Install the bypass rod (32) with new clip
retaining ring (31), if removed .
4 . Install the new retaining ring (33) .
5 . Install the bypass arm (34) .
6 . Install the retaining ring (35) .
figure 22, bypass arm and rod
30
31
32
33
34
35