Cub Cadet T2-HP - Manual (Page 35)

T2 ® 31
figure 24, filter assembly
fIlTer assembly
figure 25, pump/motor Cylinder block assembly
CylInder blOCks
Refer to Figure 25
Inspect each component of the cylinder block
assemblies for wear or damage . Inspect the
cylinder blocks’ running surface for scratches .
Replace if necessary .
NOTE: During separation of the cylinder
blocks, take care not to damage the
surfaces of the pistons and block.
Apply a thin coating of oil to all compo-
nents of the cylinder block assemblies
before reassembly.
After reassembling the cylinder block compo-
nents, set aside until ready for installation of
the center section and swashplate . Refer to
pages 28 and 30 .
Refer to Figure 24
disassembly
1. Remove the magnet (28) and the filter (27).
The filter can be removed without damaging
the filter base.
2. Remove the deflector (29).
3 . Inspect the check plugs (24, 25) . Remove
if necessary .
4. Inspect the filter base (26). Remove/replace
if necessary .
Inspection
1 . Inspect all parts for wear or damage . Re-
place as necessary .
assembly
1. Install the filter base, if removed.
2 . Install the check plugs, if removed . Refer to
torque chart on page 15 .
3. Install the deflector (29).
4. Install a new filter (27) and the magnet
(28) .
Pistons
Thrust Washers
Cylinder Block
Springs
28
27
29
24
26
22
20
25