Cub Cadet RZT-S Zero Electric - Manual (Page 39)

Brakes and Drive System
35
9. Slide the bushing and the bearing off of the drive
axle.
10. Remove the thrust bearing.
11. Remove the nut securing the drive gear to the drive
axle. See Figure 3.31.
NOTE: The nut is installed with Loctite #271 thread-locker.
12. Remove the brake shaft assembly. See Figure 3.32.
13. Slide the bushings off of the brake shaft.
14. Slide the washer and the spring off of the brake shaft.
See Figure 3.33.
15. Slide the dog clutch off of the brake shaft.
NOTE: The dog clutch is spring loaded to engage the spur
gear. When the by-pass lever is operated, the dog
clutch slides out of the spur gear. This disconnects
the Drive axle from the electric motor.
Figure 3.31
Drive axle
Drive gear
Bushing
Needle bearing
Nut
Spacer
Ball bearing
Figure 3.32
Brake shaft assembly
By-pass fork
Figure 3.33
Bushing
Dog
clutch Spring
Washer
Bushing
spur gear
Brake shaft