Cub Cadet RZT-S Zero Electric User Manual

Page 152

RZT-S Zero

A10

24.

Install the front cover using the four black shoulder
screws with a T-30 torx driver.

25.

Install the seat:

25a. Place the seat on the seat bracket.

25b. Install the two shoulder bolts and nuts so that

the nuts are on the inboard side.

NOTE: When tightening the shoulder bolts and

nuts, make sure the shoulders are in the
holes of the seat bracket.

25c. Run the seat switch harness through the slot

in the seat bracket. See Figure 27.

25d. Plug the seat switch harness into the seat

switch.

NOTE: Push the excess wire from the wire harness

into the seat box hole.

26.

Install the cargo net.

27.

Perform the pre-delivery checks by following the pre-delivery check list.

28.

Fully charge the batteries.

29.

Test drive the mower in a safe area.

NOTE: Check all safety and control features. Do not put an unsafe mower in to service.

Figure 26

Screws

Figure 27

Seat switch harness

Seat switch