Cub Cadet RZT-S Zero Electric - Manual (Page 100)

RZT-S Zero
96
To Start: Sit in seat Starter disable Won't start until condition
met. 0 volts at pin B3 and B4 Seat switch is not being
depressed, poor connec-
tion, faulty switch, dam-
aged harness
To Start: Push blade knob
down/off Starter disable Won't start until condition
met. 5 volts at pin B5 and B6 PTO switch is ON, defec-
tive switch or a short in the
harness
To Start: Remove foot from
drive pedal Starter disable Won't start until condition
met. Throttle signal not at cali-
brated neutral voltage Drive pedal is not in a neu-
tral position or the TPS is
out of calibration
To Start: Place foot on
brake pedal Starter disable Won't start until condition
met. 0 volts at pin B1 Brake pedal is not
depressed, poor connec-
tion, faulty switch, dam-
aged harness
To Start: Press and hold
start/stop button Starter disable Won't start until condition
met. Waiting for operator to
press and hold start but-
ton Sometimes this condition
will appear to be met (the
graphic on the screen
changes) but the tractor
does not start (contactor
doesn't close) - This could
be a faulty VCM or com-
munication issue on the
control panel
Blades off: Overload /
Raise deck, restart blades Operator error Disables Blades The speed of one or both
deck motors has fallen
below 2400 RPM for more
than 1 second The blade speed is to low
for current cutting condi-
tions, the deck has stalled
due too much grass mate-
rial being cut at once or a
mechanical binding of the
deck motor.
Message
Message
type
Mower's action
Code
number
(engineering
screen)**
Trigger Possible causes