Cub Cadet RZT-S Zero Electric - Manual (Page 102)

RZT-S Zero
98
Stopped: Left hub fault /
Restart, if problem persists
contact service Fault Disables Blades and Drive 32 Motor hall sensor fault Disconnected harness
connector, damaged har-
ness, corrosion, faulty
motor
Overload: Slow down or
raise deck Fault Disables Blades and Drive 64 Controller under voltage Battery voltage too low,
poor connection, corrosion
Stopped: Left hub fault /
Restart, if problem per-
sists contact service Fault Disables Blades and Drive 128 POST static gating test Controller failure
Stopped: Left hub fault /
Restart, if problem per-
sists contact service Fault Disables Blades and Drive 512 Instantaneous phase over
current Motor pulling too much
current, short bursts
Stopped: Left hub fault /
Restart, if problem per-
sists contact service Fault Disables Blades and Drive 1024 Motor has reached at tem-
perature of 105
o
C
Motor over loaded, faulty
Stopped: Left hub fault /
Restart, if problem per-
sists contact service Fault Disables Blades and Drive 2048 Throttle voltage outside
range N/A
Stopped: Left hub fault /
Restart, if problem per-
sists contact service Fault Disables Blades and Drive 4096 Instantaneous controller
over voltage Batteries over charged,
usually from regen. brak-
ing
Stopped: Left hub fault /
Restart, if problem per-
sists contact service Fault Disables Blades and Drive 8192 Internal error Controller failure
Stopped: Left hub fault /
Restart, if problem per-
sists contact service Fault Disables Blades and Drive 16384 POST dynamic gating test Controller failure
Message
Message
type
Mower's action
Code
number
(engineering
screen)**
Trigger Possible causes