Cabletron Systems 2H23-50R - Manual (Page 79)

General Configuration Screen
2H23-50R/2H33-37R User’s Guide 5-29
Figure 5-13 COM Port Warning Screen
4. Use the arrow keys to highlight YES. Press ENTER.
5. If the port was ENABLED, proceed to step 6. If the port was
DISABLED, use the arrow keys to highlight SAVE at the bottom of
the screen, then press ENTER.
6. When the message “SAVED OK” displays, the edits you made are
saved.
!
CAUTION
If the COM port is reconfigured without a valid IP address set
on the device, the message shown in
Figure 5-13 displays.
Do not continue unless the outcome of the action is fully
understood. If the WARNING screen displays, proceed to
step 4. Otherwise, proceed to step 5.
NOTE
Exiting without saving causes the message “NOT SAVED --
PRESS SAVE TO KEEP CHANGES” to display. Exiting without
saving causes all edits to be lost.
WARNING
17421-52
THE COM PORT HAS BEEN RECONFIGURED AND THERE IS NO IP
ADDRESS SET FOR THIS DEVICE. YOU WILL NO LONGER BE ABLE
TO MANAGE THIS DEVICE. DO YOU STILL WISH TO RECONFIGURE
THIS COM PORT?
YES NO