C.2.1 setting the mode switches, C.2.1, Section c.2.1 – Cabletron Systems 2H23-50R User Manual

Page 170

Appendix C: Optional Installations and Mode Switch Bank Settings

C-4

2H23-50R/2H33-37R User’s Guide

Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See

Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off the chassis.

To reinstall the chassis cover, perform the removal procedures in reverse.

Figure C-1

Removing the Chassis Cover

C.2.1

Setting the Mode Switches

Figure C-2

shows the location of the mode switches and the switch

settings for normal operation. These switches are set at the factory and do
not need to be changed.

2286-3

Chassis
Cover

Chassis

Cover Screws (7)

Note: If the device was rack mounted, the four screws fastening the cover to the
front panel are removed and installed along with the rackmount brackets.

Front
Panel

This manual is related to the following products:

2H33-37R