Cabletron Systems 2H23-50R - Manual (Page 117)

Repeater Port Configuration Screen
2H23-50R/2H33-37R User’s Guide 5-67
Figure 5-26 Repeater Port Configuration Screen
The following are definitions for each field of the Repeater Port
Configuration screen:
PORT# (Read-only)
Indicates the repeater port on the connector selected in the CONNECTOR
field. Refer to
Table 5-8 for the connector (CONN)/repeater port
relationship on the device.
Table 5-8 CONN/Repeater Port Relationship
2H23-50R or 6H123-50 2H33-37R or 6H133-37
CONN 1 = Repeater ports 1 – 12 CONN 1 = Repeater ports 1 – 12
CONN 2 = Repeater ports 13 – 24 CONN 2 = Repeater ports 13 – 24
CONN 3 = Repeater ports 25 – 36 CONN 3 = Repeater ports 25 – 36
CONN 4 = Repeater ports 37 – 48
2H23-50R LOCAL MANAGEMENT
Repeater Port Configuration
Device Type: 2H23-50R Firmware Revision: XX.XX.XX
Slot Number: X BOOTPROM Revision: XX.XX.XX
PORT# NETWORK# LINK STAT. CURRENT OPER. MODE DESIRED OPER. MODE PORT STAT .
1 1 No Link Unknown [Auto-Neg] [Disabled]
2 2 No Link Unknown [Auto-Neg] [Enabled]
3 1 Link 10Base-T [Auto-Neg] [Enabled]
4 2 No Link Unknown [Auto-Neg] [Enabled]
5 2 No Link Unknown [Auto-Neg] [Enabled]
6 2 No Link Unknown [Auto-Neg] [Enabled]
7 2 No Link Unknown [Auto-Neg] [Enabled]
8 2 No Link Unknown [Auto-Neg] [Enabled]
9 2 No Link Unknown [Auto-Neg] [Enabled]
10 2 No Link Unknown [Auto-Neg] [Enabled]
11 2 No Link Unknown [Auto-Neg] [Enabled]
12 2 No Link Unknown [Auto-Neg] [Enabled]
SAVE SET ALL PORTS: [Auto-Neg] CONNECTOR #: [1] EXIT RETURN
Event Message Line
2286_111