Cabletron Systems 2H23-50R - Manual (Page 111)

Broadcast Suppression Screen
2H23-50R/2H33-37R User’s Guide 5-61
5.16 BROADCAST SUPPRESSION SCREEN
The Broadcast Suppression screen, Figure 5-23 , enables the user to set a
desired limit of receive broadcast frames that are switched out to the other
Network, Fast Ethernet, or HSIM ports.
To access the Broadcast Suppression screen from the Device Specific
Configuration Menu screen, use the arrow keys to highlight the
BROADCAST SUPPRESSION menu item and press ENTER. The
Broadcast Suppression screen displays.
Figure 5-23 Broadcast Suppression Screen
NOTE
The Broadcast Suppression screen is not available if the
operational mode of the device is set to SECURE FAST VLAN.
This screen may only be used when the device is configured to
operate as an 802.1D or 802.1Q switch.
Broadcast frames received above the threshold setting are
dropped.
Firmware Revision: XX.XX.XX
Broadcast Suppression
22861-56
Device Type: 2H23-50R
BOOTPROM Revision: XX.XX.XX
PORT #
1
2
3
4
5
6
7
8
9
10
Time Since Peak
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
Peak Rate
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
Threshold
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
2H23-50R LOCAL MANAGEMENT
Event Message Line
Total RX
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
Reset Peak
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
RETURN
RETURN SAVE EXIT