COP-USA DVR2508-FD - Manual (Page 41)

DVR User Manual
35
Step 3: Connect internet. If you have a DHCP server running and would like your DVR to automatically obtain an IP address and
other network settings from that server, check the checkbox beside "Obtain an IP address automatically". Then the device will
distribute IP address, subnet mask, and gateway IP and DNS server. If you want to configure your own settings, please input the
IP address, Subnet mask, Gateway DNS server manually. You can also check the PPOE checkbox to enable this feature and
then enter username and password. Once the setup is completed, your DVR will automatically dial up into your network.
Step 4: No matter what kinds of way to connect internet, you should test the effectiveness of the network by clicking “Test” button
after you setup the network.
Step 5: If the network is well connected, please click “Apply” button to save settings.
4.6.2 Sub-stream
Step 1: Enter into MenuSetupNetwork Sub-stream tab. Refer to Fig 4-30:
Step 2: Select fps, resolution, quality, encode and max bit rate
Step 3
: Select “All” to setup all channels with the same parameters.
Fig 4-30 Network Configuration-Sub Stream
Parameter Meaning
Resolution Support CIF
FPS Range from: 1-6(PAL) /1-7(NTSC)
Encode Two options: VBR and CBR
Quality
The higher the value is, the clearer
the record image. Six options:
lowest, lower, low, medium, higher
and highest.
Max Bitrate Range from: 256kbps~1792kbps