COP-USA DVR2508-FD - Manual (Page 37)

DVR User Manual
31
Fig 4-22 Sensor-Schedule
4.5.2 Motion
Motion includes two sub menus: motion and schedule.
The steps to set up motion alarm are as follows:
Step1: Enter into MenuSetupAlarmMotion tab. Refer to Fig 4-23:
Fig 4-23 Alarm Configuration-Motion
Step2: Enable motion alarm, set alarm hold time which refers to the time till which the system will wait for further detection of
motion. Eg. If the holding time is set to 10 seconds, once the system detects a motion, it will go into alarm but would not detect