Panasonic OMNIVISION PV-DM2791 User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
READ AND RETAIN ALL SAFETY AND
OPERATING INSTRUCTIONS. HEED
AIL
WARNINGS INTRE MANUAL AND ON UNIT
OUTDOOR ANTENNA INSTALLATION
I
INSTALLATION
1 POWER SOURCE CAUTION
Operate only from power source indicated on unit
or in this manual. If uncertain, have your Electric
Utility Service Company or Video Products Dealer
verify your home power source.
2 POWER CORD PLUG
For safety, this unit has a polarized type plug (one
wide blade), or a three-wire grounding type plug.
Always hold the plug fimnly and make sure your
hands are dry when plugging in or unplugging the
AC power cord. Regularty remove dust, dirt, etc.
on me plug.
POLARIZED PLUG CAUTION:
The plug fits into outlet one way. If it cannot be fully
insertea try reversing it. If it still vnll not fit, have an
electrician install the proper wall outlet. Do not
tamper with the plug.
GROUNDING PLUG CAUTION:
The plug requires a three-hole grounding outlet.
If necessary, have an electrician install the proper
outlet. Do not tamper with the plug.
3 POWER CORD
To avoid unit malfunction, and to protect against
electrical shock, fire or personal injury:
- Keep power cord away from heating appliances
and walking traffic. Do not rest heavy objects on,
or roll such objects over the power cord.
- Do not tamper with the cord in any way.
- An extension cord should have the same type
plug (polarized or grounding) and must be
securely connected.
- Overfoaded wall outlets or extension cords is a
I
fire hazard.
]
- Frayed cords, damaged plugs, and damaged or
I
cracked wire insulation are hazardous and should
I
be replaced by a qualified electrician,
j 4 DO NOT BLOCK VENTILATION HOLES
' Ventilation openings in the cabinet release heat
I generated during operation. If blocked, heat
' build-up may result In a tire hazard or heat
! damage to cassettes or discs.
I
For your protection:
a. Never cover ventilation slots while unit is ON,
^ or operate unit while placed on a bed, sofa,
I nug, or other soft surface,
i
b. Avoid built-in installation, such as a book case
' or rack, unless properly ventilated.
I
5 AVOID EXTREMELY HOT LOCAЛONS OR
! SUDDEN TEMPERATURE CHANGES
Do not place unit over or near a heater or radiator,
:
in direct sunlight, inside closed vehicles,
I in high temperature [over 95 “F (35 °C)j, or in over
75% humidity. If unit is suddenly moved from a
I cold place to a warm one, moisture may
! condense in unit and on the tape causing
i damage. Never subject unit to vibration, impact,
or place it so that the surface is tilted as internal
parts may be seriously damaged.
6 TO AVOID PERSONAL INJURY
• Never place unit on support or stand that is not
firm, level, and adequately strong.
The unit could fall causing serious
injury to a child or adult and
damage to the unit.
• Move any appliance and cart
combination with care.
Quick slops, excessive force, and
2
uneven suriaces may cause objects to overturn.
^ « Carefully follow all operating instmctions.
SAFE ANTENNA AND CABLE CONNECTION
An outside antenna or cable system must be property
grounded to provide some protection
against built up static charges
and voltage. Section 810
of the National Electrical
Code, ANSt/NFPA 70 (in
Canada, part 1 of the
Canadian Electrica) Code)
provides information
regarding proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location of
antenna discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
KEEP ANTENNA CLEAR OF HIGH VOLTAGE
POWER LINES OR CIRCUITS
Locate an outside antenna system well away from power
lines and electric light or power circuits so it wilt never
touch these power sources should it ever fall. When
installing antenna, absolutely never touch power lines,
circuits or other power sources as this could be fatal.
USING THE UNIT
Before unit is brought out of storage or moved to a new location,
refer again to the INSTALLATION section of these safeguards.
1 KEEP UNITWELL AWAY FROM WATER OR
MOISTURE,
such as vases, sinks, tubs, etc.
2 IF EXPOSED TO RAIN, MOISTURE, OR
STRONG IMPACT,
unplug unit and have it inspected
by a qualified service technician before use.
3 ELECTRICAL STORMS
During a lightning storm, or before leaving unit unused for
extended periods of time, disconnect all equipment from
the power source as well as the antenna and csfele system.
4 WHEN UNIT IS PLUGGED IN
• DO NOT OPERATE IF:
- liquid has spilled into unit.
• unit was dropped or otherwise damaged.
- unit emits smoke, malodors, or noises.
Immediately unplug unit, and have it inspected by a
service technician to avoid potential fire arid shodt hazards.
• Never drop or push any object through openings in iriiL
Touching interria! parts m^ cause eiectric shock or fire hazard.
Do not ^ any foreign object on the tray.
• Keep magnetic objects, such as speakers, away from
unit to avoid electrical interference.
5 USING ACCESSORIES
Use only accessories recommended by the manufacturer
to avoid risk of fire, shock, or other hazards.
6 CLEANING UNIT
Unpfug unit. Use a dean, dry, chemicaIN untreated doth to
genUy remove dust or debris. DO NOT USE cleaning fluids,
aerosols, or forced air that could over-spray, or seep into unit and
cause electrical shock. Any substance, such as wax, adhesive
tape, etc. may mar the cabinet surface. Exposure to greasy,
humid, or du^ areas may adversely affect internal parts.
SERVICE
1 DO NOT SERVICE PRODUCT YOURSELF
If, after carefully following detailed operating instmctions, the
unit does rK»t operate properly, do not attempt to op^ or
remove covers, or make any adjustments not described in the
manual. Unplug unit and oontad a qualified service technician.
2 REPLACEMENT OF PARTS
Make sure the service technician uses only parts specified
by the manufacturer, or have equal safety characteristics
as original parts. The use of unauthorized substitutes may
result in fire, electric shock, or other hazards.
3 SAFETY CHECK AFTER SERVICING
After unit is serviced or repaired, request that a thorough safety'
check be done as described in the manufacturer’s service
literature to insure video unit is in safe operating condition.