Connect the lw/mw loop antenna, 5 connect the surround speaker cord, 4 connect the speaker cables – Panasonic SC-CH950 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Connect the LW/MW loop antenna.
1. Attach the antenna holder with screws (included) to the rear
panel of the sound processor.
2. Clamp the antenna to the antenna holder and connect the
antenna terminal to the rear panel of the tuner amplifier.
3. Position the loop for the best reception.
You may attach the LW/MW antenna holder to a rack or other
structure.
Notes:
•To minimize noise pickup, keep the LW/MW loop antenna
away from the speaker cable, power cord, and metal sur
faces.
•For better reception, keep the LW/MW loop antenna cord
along the heat prevention cover, and away from the flat
cable.
5
Connect the surround speaker cord.
4
Connect the speaker cables.
Connection of speaker cables
1. Strip off the outer covering, and
twist the center conductor.
Make sure the bare ends of the wires are not unraveled.
(If they are, twist them tight again.)
2. insert the wire to the rear panel
of the speakers, and then pull
down the lever.
3. Insert the wire to the rear panel
of the tuner amplifier, and closej
the lever.
Notes:
•To prevent damage to circuitry,
never short-circuit positive
{+)
and negative (-) speaker wires.
•Be sure to connect only positive (red) wires to positive
(-«-) terminals and negative (black) wires to negative
(-) terminals.
Connect the AC power supply cord after you
have connected all other cables and cords.
For areas except Australia, New Zealand
Insertion of Connector
Even when the connector is per
fectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as
shown in the drawing.
However there is no problem
using the unit.
Connector
For areas except Australia, New Zealand
If the power plug will not fit your socket, use the power
plug adaptor (included).
Et
Note:
•Be sure to connect speaker cables before connecting the AC
power supply cord.