To record with desired tone quality, To erase a recorded sound (deck 2), Concerning the leader tape – Panasonic SC-CH950 User Manual
Page 44: Making a recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
■ To record with desired tone quality
You can make a recording with the equalizer or simulated listening
environment effect. (See pages 54-59.)
When playing back such recordings, press ON/FLAT on the sound
processor to set “FLAT".
■ To erase a recorded sound (Deck 2)
When you make a new recording on a previously recorded tape, the
new recording will automatically erase what was previously re
corded. To erase a recorded sound without making a new record
ing, perform the following steps.
Note:
Be sure to disconnect the microphone from the microphone jack
before following the steps.
[Steps 5) and 6) also available from the remote control]
1) Press the TAPE input select button on the tuner amplifier.
2) Press DOLBY NR so that “B” or “C" is turned off.
3) Insert the recorded tape into the cassette holder of deck 2.
4) Select the desired reverse mode.
5) Press REC PAUSE.
6) Press the playback button corresponding to the side to be
erased.
■ Concerning the leader tape
The leader tape is the first few revolutions that is no recordings can
be made.
Making a Recording
(continued)
(recordings can be made)
(No recordings can be made)