Problem, Probable cause(s), Suggested remedy – Panasonic SC-CH950 User Manual
Page 79
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Problem
Probable cause(s)
Suggested remedy
When there is a television set nearby
The picture on the TV
disappears or stripes
appear on the screen.
The location and orientation of the antenna are
incorrect.
If you are using an indoor antenna, change to an
outdoor antenna.
The wiring at the back of the system is unsuitable.
Separate the antenna wire of the TV set from the
system.
While listening to ta pes
Sound is iow, intermittent,
or poor quaiity, noisy,
scratchy, or unsteady.
Heads are dirty.
Clean the heads.
The Dolby noise reduction is set in the wrong
position.
Set it to match the Dolby NR recording mode.
The deck does not enter the
recording mode.
The erase-prevention tabs are removed from the
cassette.
Attach tape to cover the space left by removal of the
erase-prevention tabs.
While listening to compact discs
The tray does not close
when you load a disc and
press the OPEN/CLOSE
button.
The disc is not positioned correctly in the disc tray.
Reinsert the disc.
The display will not show
the total number of tracks
and total time when you
load a disc. Disc play does
not start when you press
the play button.
The disc is not positioned correctly in the disc tray.
The disc is loaded upside down.
Reload the disc.
The disc is dirty.
Wipe the disc with a soft cloth.
The disc is scratched.
Replace the disc with a new one.
The disc is badly warped.
The disc is a nonstandard one.
Replace the disc with a different one.
There is condensation inside the disc player.
Switch the power ON, and then wait for
20-30 minutes before using the disc player.
A certain part of the disc
cannot be played.
The disc is dirty.
Clean the disc with a soft cloth.
The disc is scratched.
Skip the scratched part of the disc (skip play).
While using the remote control
The system cannot be
operated with the remote
control.
The batteries are installed in the reverse polarity.
Re-insert the batteries in the correct polarity.
The batteries are worn.
Replace the batteries with new batteries.
79