Panasonic SC-CH950 - Manual (Page 68)

Using the Timer
(continued)
To use the sleep timer
You can use this timer function to switch the power to the standby
mode at a desired time (within a range of
1 minute to 120 minutes
from the present time).
It is convenient to use the sleep timer function when you want to fall
asleep while listening.
...11
t -
J
1
r-nnl __ loco
I ■ «»Q
l
1( CLOCK/riMER . SET
a-
532> è
ócbci)d>d3
diÓ<Ì)CfDCÌ>
cfòSaS
□ÙÙòo
s s s a a
cfTaaac)
asa àia
ScSìbcSò
ùùiaób
Scz3tÌD
The following example shows how to set the sleep timer for; switch­
ing the power to the standby mode after 30 minutes.
While the source is being played,
1
Select the “SLEEP” of the timer.
® Press CLOCK/TIMER.
Each time you press, the display will
change "CLOCK”, "Q REC”, “□
PLAY", “SLEEP”, in order.
Lights'
CLOCK/TIMER
The display will return to what was previously indicated if you
allow 7 or more seconds to elapse before you accomplish the
next operation.
SET (D Press SET.
Flashing'
2
Set the length of time you would like the sys­
tem to operate before it shuts off (Sleep time).
T SELECT i ® Press one of SELECT to select the de-
V I i sired length of time.
The sleep time set by the steps above will stay in the system’s
memory.
If you want to operate the system again on the same sleep
time previously set, just press SLEEP on the remote control.
When you want to change the time setting, follow the above
procedure from the beginning.
■ To confirm the time remaining on the sleep
timer
Press CLOCK/TIMER to select “SLEEP”.
CLOCK/TIMER
C □
The display shows “SLEEP”, and then the time remaining on the
sleep timer will show.
■ To cancel the sleep timer mode
Press SLEEP on the remote control to go off the
SLEEP indicator.
a
SET @ Press SET.
68