Panasonic SC-CH950 - Manual (Page 27)

Automatic memory presetting
When you preset broadcast frequencies to the memory, you can
then easily select any of those broadcast frequencies by pressing
one of the preset-tuning buttons on the unit or remote control. There
are two methods for presetting broadcast frequencies in the mem­
ory; the automatic method (see below) and the manual method.
(See page 28.) Select whichever method you prefer. When you
memorize a new frequency on a preset channel, it cancels the
frequency previously memorized on that preset channel.
When this method is used, the frequencies of the selected broad­
cast stations are automatically preset (in sequence from lower to
higher frequencies) into memory; “channels" 1 to 39 are available
for the presetting of FM stations, and "channels” 21 to 39 are
available for MW stations, and “channels" 31 to 39 are available for
LW stations.
When you preset a broadcast station to a channel that has already
been preset, the prior presetting will be erased, so if, for example,
FM frequencies are preset to channel 1 to 39 and then MW frequen­
cies are preset, the first MW frequency will be preset to channel 29
(thus erasing the FM presetting to channel 29), the second MW
frequency will be preset to 30 (erasing FM 30), and so on.
Switch ON the power.
(Step 1 also available from the remote control)
1
Press BAND to select FM.
Each time you press BAND, "FM”, “MW”, “LW’ will appear in
order.
2
Press and hold one of the TUNING until the
display shows the lowest frequency.
Press TUNING momentarily to stop changing frequencies
when the displayed frequency approaches the lowest fre­
quency. Tap TUNING a few times until the lowest frequency is
reached.
3
Press and hold MEMORY to start the memory.
Keep MEMORY depressed until MEMO indicator starts flash­
ing, then release the button.
I857>VCB
\ I /
n I I I l"/^‘
I f I " i f f I
r/i/f LJ I I I /
r l l U I .
MEMO indicator will flash.
After completing the memory presetting, MEMO indicator will
go out and the display will show the last preset frequency.
4
Press BAND to select MW, and follow steps 2,
3.
Repeat above procedure tor LW broadcast station preset.
To confirm the stations which are preset to each channel, press one
of PRESET. Each time you press it, the display will show in which
channel you have preset the broadcast station.
Use the manual memory (see page 28) if the signal strength is low,
preventing the station from being memorized with the auto memory,
or if the signal strength is excessive, causing the frequency to drift.
27