Press (tps) button while the tape is playing, To fast forward or rewind the tape, Press m-4 (tps) button while the tape is stopped – Panasonic SC-CH950 User Manual
Page 40: Listening to tapes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Listening to Tapes
(continued)
---- )J C-T3
— r-
1-
___ _
..... ..
S£
Oeee «
O O O V
g=C
To find the beginning of a program
(TPS: tape program sensor)
(Also available from the remote control)
Press
(TPS)
button
while
the
tape
is
playing.
While a TPS operation is taking place, PLAY indicator will flash.
If the forward side (O) of the tape is playing:
3
..The tape will play from the beginning of the next
program.
□ ..The tape will rewind to the beginning of the present
program. Then the program will play again.
If the reverse side (<) of the tape is playing:
The reverse operation should take place;
L
..The tape will rewind to the beginning of the present
program. Then the program will play again.
□ ..The tape will play from the beginning of the next
program.
Notes:
TPS (Tape Program Sensor) is the function that searches for the
silent passage in a tape program. So, it may fail to operate correctly
in the following situations;
•When there is no dead space between tape programs (for exam
ple, when you are playing a tape recorded from a microphone).
•When the interval between programs (dead space) is less than
4 seconds.
•When there is a particular low-level passage or silent passage in
the middle of a program.
•When there are less than 10 seconds from the point where TPS
starts to the beginning of the program.
•When there are less than 10 seconds from the point where TPS
starts to the beginning of the next program.
•When a tape has been recorded with fade-ins (the function that
increases the volume level gradually at the beginning of a pro
gram) and fade-outs (the function that decreases the volume level
gradually at the end of a program).
To fast forward or rewind the tape
(Also available from the ramote control)
Press
M-4
(TPS)
button
while
the
tape
is
stopped.
( T P S ) I
The tape will start moving at high speed in the direction of the arrow.