Panasonic CF-M32 Series - Manual (Page 40)

Infrared Data Communications
Your computer is equipped with an infrared communication port enabling you to transfer
data without a cable.
1
Set the address of your infrared communications port to
enable
Run the Setup Utility, then set infrared address for [Infrared Port] and set [Dis­
abled] for [ASK Mode] in [Supervisor Setup]. (G’pageTS)
2
Install the Windows 95 infrared communication driver
To install the infrared communication driver after reinstallation;
You must insert the Windows 95 CD-ROM (included) after Step 8 . below.
Therefore a PC Card-compatible CD-ROM drive should be connected. (See the
manual included with your CD-ROM drive for details on how to connect it,)
1. Click [Start], then [Settings], then [Control Panel], Double-click the [Add New
Hardware],
2. When the [Add New Hardware Wizard] opens, click [Next].
3. The following message will be displayed: "Do you want Windows to .search for
your new hardware?". Select [Nol, then click [Next],
4. Under [Hardware types], select [Infrared], then click [Next],
5. When the [Add Infrared Device Wizard] opens, click [Next].
6. Under [Manufacturers], .select [Standard infrared devices], then click [Next],
7. In the port selection window, select [Generic Ir Serial Port (COM2)], then click
[Next],
8 . Select [Use default ports], then click [Next].
The infrared communication driver will be set up.
9. Click [Finish],
40