Yamaha REX50 - Manual (Page 8)

2 ; GENERAL OPERATION
/ MEMORY CONFIGURATION /
The REX50 has a total of 90 internal memory locations.
Locations 1 through 30 are READ-ONLY MEMORY con­
taining the 30 preset effect programs. These locations
cannot be written to or changed in any way. The ef­
fect programs contained ih memory locations 1 through
30 are:
VIem.
No.
Program Name
Mem.
No.
Program Name
1 REV 1 HALL 16 REVERB & GATE
2 REV 2 ROOM 17 PITCH CHANGE A
3 REV 3 VOCAL 18 PITCH CHANGE B
4 REV 4 PLATE 19 PITCH CHANGE C
5 EARLY REF. 1 20 PAN
6 GATE REVERB 21 DISTORTION
7 DELAY L,R 22 DIST. + REV HALL
8 STEREO ECHO 23 DIST.+REV PLATE
9 STEREO FLANGE 24 DIST.+GATE REV
10 CHORUS 25 D. +REVERSE GATE
11 STEREO PHASING 26 DIST.+DELAY
12 SYMPHONIC 27 DIST.+ECHO
13 REVERSE GATE 28 DIST.+FLANGE
14 ADR-NOISE GATE 29 DIST.+CHORUS
15 COMPRESSOR 30 DIST. + SYMPHONIC
A complete description of each effect program and its
parameters is given in "3: DESCRIPTIONS OF THE EF­
FECT PROGRAMS & THEIR PARAMETERS” on page
10 .
Locations 31 through 90 are READ/WRITE MEMORY
which can be used to store your own edited versions
of the preset programs.
/ SELECTING AN EFFECT/MEMORY
/ LOCATION ____________ /
® Press the MEMORY key to engage the memory
selection mode. This is not necessary if the memory
selection mode is already active, but it's a good habit
to get into to ensure smooth operation.
(D Press the A or V key to increment or decrement the
memory location number shown on the LED display.
Hold either of these keys down for continuous in­
crementing or decrementing. The name of the pro­
gram corresponding to the currently selected
memory location will be shown on the LCD, or " ♦ * *
NO DATA * * * " will be displayed if a memory loca­
tion between 31 and 90 is selected into which an
edited effect program has not been stored. Note that
at this stage the LED memory number display is
flashing, indicating that although a new location has
been selected, its contents have not yet been
7 recalled.
)When the desired memory location/effect has been
selected, press the RECALL key. The LED memory
number display will stop flashing and the selected
effect will be engaged.
/
BYPASSING THE EFFECT
/
There are two ways to switch the selected effect in and
out: ® with the control panel BYPASS switch and (
2 )
with a footswitch connected to the connector-panel
BYPASS footswitch jack. An optional Yamaha FC5
Footswitch can be used for foot-bypass control.
In either case — when the control-panel BYPASS key
or BYPASS footswitch is pressed — a bold, flashing let­
ter "B" will appear in the upper right-hand corner of
the LCD. While the "B" is visible the REX50 effect is
bypassed and the input signal is directly routed to the
output terminals (i.e. the effect is OFF). Press the
BYPASS key or footswitch a second time to turn the
effect back ON.