Yamaha REX50 - Manual (Page 5)

1: CONTROLS AND CONNECTIONS
/THE CONTROL PANEL/
YAMAHA =i
DIGITAL MULTI EFFECTOR
E X •
—
--------------- ^
o o
LI U
O
CLIP
I I
r
1 ^ 1 1 1 1
"JTILITY
1
□
-20 1
param
I
.
1 ^ 1 1
RECALL
1 1
BYPASS
I
[
--------------- ^
-o
-©
o
0 0 6 0 0
OLCD (Liquid Crystal Display)
This 16-character x 2-line liquid crystal display panel
normally displays the title of the selected effect on
the top line and a selected parameter and its value
on the bottom line. One or both lines may also be
used to display errof messages or warnings.
0LED Memory Number Display
This 2-digit numeric display shows the number of the
currently selected memory location (1 — 90). When
the LED display is continuously lit the effect cor­
responding to the number displayed is active. When
the LED display is flashing, this indicates that a new
memory location has been selected but has not yet
been recalled, leaving the previously selected effect
active.
0 Input Level Meter
The input level meter consists of three LEDs cor­
responding to - 20 dB, - 10 dB and CLIP input lev­
el. When the source (instrument or other) is
connected to the REXSO's inputs, it should be played
at the loudest level it will be played during actual use
and the rear-panel INPUT LEVEL control (THE CON­
NECTOR PANEL, 7) adjusted so the - 20 and - 10
dB LEDs light but the CLIP LED almost never lights.
O Memory Key
Pressing this key engages the memory selection
mode, allowing a new memory location to be select­
ed using the A and V keys.