Yamaha REX50 - Manual (Page 28)

NOTE: The program number/memory number
assignments made are stored in the BANK
selected in the previous MIDI CONTROL func­
tion. To program the program change/memory
number assignments for a different BANK,
return to the MIDI CONTROL mode, select the
desired BANK, then program the required
assignments.
/
FOOTSWITCH MEMORY RECALL
The REX50 permits memory selection via an optional
Yamaha FC4 or FC5 footswitch connected to the
"MEMORY" footswitch jack. The fourth function ac­
cessed by the UTILITY key - F.SW MEMORY RCL -
permits setting the range of memory location numbers
that will be selected when the footswitch is pressed.
F. SW M E M O R Y R C L
R A N G E 3 1 T O 3 5
If, for example, the RANGE parameter is set to "0 TO
30" as shown in the LCD illustration above, each time
the footswitch is pressed the next highest memory
location will be selected until the last number in the
specified range is reached. After the last number in the
specified range, the first (lowest) number is selected
and the process repeated. Reverse sequences can be
programmed by entering the highest number in the
range before the lowest, as shown below.
F . S W M E M O R Y R C L
R A N G E 3 5 T O 3 1
In this case the selection sequence is: 35 34 -> 33
^ 32 -> 31 ^ 35, etc.
27