Yamaha REX50 - Manual (Page 24)

Distortion Level (DISTORTION): 0 - 100%
Sets the "degree" or "depth" of the distortion por­
tion of the effect.
Flange Balance (FLANGE BAL): 0 - 100%
Determines the amount of flange effect applied to
the distortion sound.
Modulation Frequency (MOD. FRQ): 0.1 Hz — 20.0 Hz
Sets the speed of modulation, and hence the rate at
which the effect varies.
Modulation Depth (MOD. DEPTH): 0% - 100%
Sets the amount of delay time variation, thus ad­
justing the depth of the effect.
Modulation Delay (MOD. PLY): 0.1 ms — 100.0 ms
This sets the basic delay time from the initial direct
sound to the beginning of the flange effect.
Feedback Gain (F.B. GAIN): 0% - 99%
Determines the amount of flange signal which is fed
back to the input of the processor for further modula­
tion. More feedback increases the overall complexi­
ty, "strength" and decay time of the effect.
Trigger Level (TRG. LEVEL): 1 - 1 0 0
Determines the amplitude of the input signal required
to trigger the effect. This parameter, in conjunction
with the RELEASE parameter below, functions ef­
fectively as a noise gate to cut out hiss and noise
when an input signal is not present. TRG LEVEL
should be set so that the effect is activated only
when a note is played on the instrument used.
Release Time (RELEASE): 5 — 32000 ms
Determines the amount of time it takes for the distor­
tion gate to close after the input signal drops below
the trigger level. Proper setting of the RELEASE
parameter is essential to allow a natural decay of the
source instrument sound.
/ 28. DIST. + FLANGE
7
Distortion Level (DISTORTION): 0 - 100%
Sets the "degree" or "depth" of the distortion por­
tion of the effect.
Chorus Balance (CHORUS BAL): 0 - 100%
Determines the amount of chorus effect applied to
the distortion sound.
Modulation Frequency (MOD. FRQ): 0.1 Hz — 20.0 Hz
Sets the speed of chorus effect variation.
Delay Modulation Depth (DM DEPTH): 0% - 100%
This sets the depth or "strength" of the chorus
effect.
Amplitude Modulation Depth (AM DEPTH): 0% —
100 %
Sets the amount by which the amplitude (level) of
the input signal is varied.
Trigger Level (TRG. LEVEL): 1 - 1 0 0
Determines the amplitude of the input signal required
to trigger the effect. This parameter, in conjunction
with the RELEASE parameter below, functions ef­
fectively as a noise gate to cut out hiss and noise
when an input signal is not present. TRG LEVEL
should be set so that the effect is activated only
when a note is played on the instrument used.
Release Time (RELEASE): 5 — 32000 ms
Determines the amount of time it takes for the distor­
tion gate to close after the input signal drops below
the trigger level. Proper setting of the RELEASE
parameter is essential to allow a natural decay of the
source instrument sound.
/ 29. DIST. -I- CHORUST
23